Ryobi C430 will only run on full choke. What can be done to correct this.

Asked by Dr. Robert on 05/18/2014 2  Answers

ManualsOnline posted an answer 10 years, 6 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
5 Check for these probable causes: 1) Check to see if the air filter needs to be cleaned or replaced. 2) Clean the fuel line 3) Check fuel for water. If water is found in the fuel, drain and add fresh fuel. 4) Check to see if the plug could be dirty 5) The timing may need to be adjusted. There is a silver screw by the choke that you can adjust both ways. Most likely, one of these will be the culprit. If all else fails, contact Ryobi directly at (800)860-4050 or you can take it to the nearest service center at the address below: BOWERSOX EQUIPMENT CO 2911 OGLETOWN ROAD NEWARK, DE 19713 Phone: (302) 368-7006 Hope this helps.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.