my trimmer wont run. I was using it and it came to a slow stop and now it wont start. I think I may have a fuel supply problem. What do you think

Asked by ernest on 03/15/2010 2  Answers

ManualsOnline posted an answer 14 years, 8 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
0 Mine froze on the second try. I will never Purchase one of their prodcuts again.
Was this answer helpful?
0 Cylinder heads work loose. Hold block in one hand & see if there is movement. If so, then mounting bolts are loose & need tightening to stop air getting in & cutting the engine. Also, cylinder gasket may be split. If so replace asap, not too difficult, but be careful to note & retain all bolts. Or take to service outlet, time should be 90mins + gasket cost about 6 euros. Finally, always make sure you are very accurate with the fuel mix when making it up, excessive 2 stroke oil is as bad as too little
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.