The gas lines rotted. I am replaceing them but do not know how to attach them. I need a diagram

Asked by jim on 07/12/2008 5  Answers

ManualsOnline posted an answer 16 years, 3 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
4 Gas line runs to the primer bulb. Line out of primer bulb runs into the lower nib on the carb. I am still trying to figure out where the line from the upper carb nib goes or is it just some sort of overflow line.
Was this answer helpful?
3 Same problem I am having. The gas lines were in small short pieces so I couldn't determine where they came from. So far, I haven't had any luck finding out where they hook up to go back in place. I'm probably going to a dealer this week to see if they will give me the info I need. Most shops charge $20.00 for a question/answer session for 3-5 minutes.
Was this answer helpful?
3 I have relpaced three lines: One small line from main gas tank to carb: one small to primer: one large one from lower section of gas tank to primer. I connect two small lines to the carb...but do not know whether the primer line goes to the top connection and the main supply to the bottom of the other way around. I have tried both ways...will not crank or hit. Also cannot set throttle to hold the gas intake wide open...the latch will not catch...any suggestions?
Was this answer helpful?
0 how to change
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.