when I try the spark test I get no spark at all. Has a new plug and on-off switch. I ordered a new coil/module and in stalled it but still no luck. The coil is grounded when screwed down. Should it be grounded? I used a ohm meter to compare the new ignition and old and they come out the same. when installed they are both grounded. not sure where to go next.....if they are not to be grounded then how would I install them.

Asked by mike on 09/26/2010 2  Answers

ManualsOnline posted an answer 13 years, 6 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
0 The saw mentioned above is a cs 4600.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.