1. Manuals
  2. Lawn and Garden Support
  3. McCulloch Support
  4. Chainsaw Support
Support User Manuals
Question About McCulloch Chainsaw None
set carb...

model nu 600041c serial nu 11-134145 settings for carb.

Asked by jerry berry on 09/13/2008 1  Answer

ManualsOnline posted an answer 16 years, 1 month ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

ian posted an answer 16 years ago

0 My 610 saw has a 'ZAMA'carb fitted. I've recently fitted a rebuild kit. Not sure exactly what settings you are referring to, but assume you mean the LOW & HI needles visable from the pull start side of the saw. A start setting for both is about 3/4...1 turn open from the closed position. both are then adjusted as required depending on how worn the carb is. The third rear most screw is the idle speed adjustment which one would start off with screwed 2..3 turns to get saw going, then as the idle screw is fined tuned so the idle speed is reduced to a smoothe idle.Then the HI needle is tuned to loaed revs. Depending on your skills, it is important to ensure that the chain brake is operative, better still remove the chain and bar from the saw completly, so no chance of being injured then. If the reason for your question on settings is to do with the saw not running /starting, its fair to point out that if the saw has been running some time ago, its not relistic to think that the settings have changed markedly by them selves!......so you may need to look in other directions. Lets know how you get on. good luck
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual