1. Manuals
  2. Lawn and Garden Support
  3. Husky Support
  4. Pressure Washer Support
Support User Manuals
Question About Husky Pressure Washer 1650 PSL
Power washer wand...

I had to disassemble the handle of my power washer after my dog chewed off the hose. I opened it up and two springs flew out before I could see where they went. I reassembled the wand and the stop start handle does nothing now. No doubt I have the spings in the wrong place. I need a view of where these springs go in their proper position.

Asked by Steve on 03/21/2010 8  Answers

ManualsOnline posted an answer 14 years, 8 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

tom posted an answer 13 years, 6 months ago

5 one of the springs goes into the hose coming into the wand. that will get the on off handle to work. Question: I am missing a spring, are they both the same size. Before you ask I am not certain as to where the other spring fits.
Was this answer helpful?

Michelle posted an answer 14 years, 8 months ago

0 did you every find out where the springs go? I did the same thing. I have it all back together but cannot figure out where the springs go? HELPO
Was this answer helpful?

Steve posted an answer 14 years, 8 months ago

0 nope, noone has written back yet but you.
Was this answer helpful?

Cathy posted an answer 14 years, 6 months ago

0 I did the same thing today. Did you figure it out?
Was this answer helpful?

IggyD posted an answer 13 years, 5 months ago

0 I had a leak and took it apart, the spring flew and had no idea where to put it as well. I will try putting into the hose end that goes into the brass fitting that controls the water flow... on a side note, that is the worst possible design. To control the water flow buy having the plastic move back and forth over the fitting.. no wonder it leaks after one use as that movement causes wear on the O-ring... Idiots
Was this answer helpful?

IggyD posted an answer 13 years, 5 months ago

0 On the 1800 model the spring goes into the water feed tube (trigger side). I still have the water leaking out while in rest mode and even more when the trigger is depressed. I think the cause is the spring is highly over stressed and is taking a set which decreases the amount of pressure it delivers in both trigger positions. I am going to try 2 or 3 different springs that have less stress to see if that will stop the problem. I will post my results here.
Was this answer helpful?

jon posted an answer 12 years, 4 months ago

0 i have the exact same problem on a 2000 psi husky model. Theres a fat spring and a skinny spring and cannot figure out where they should be located. Has anyone figured this out or have a picture??
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual