1. Manuals
  2. Lawn and Garden Support
  3. Countax Support
  4. Lawn Mower Support
Support User Manuals
Question About Countax Lawn Mower Rider 30
how do I fit a new drive belt to a countax rider 3...

how do I fit a new drive belt to a countax rider 30

Asked by Ruth on 05/13/2012 4  Answers

ManualsOnline posted an answer 12 years, 6 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Geoff posted an answer 12 years, 6 months ago

5 This job isn't easy. 1st Contact Countax in Oxford for a diagram for the route of the belt as it goes around 2 additional pulley's. Remove the 2 bolts holding the gearbox/axle to the chassis on the right, just slacken the bolts on the left and remove the single bolt which fixes the Gearbox the the chassis at the back. Ensure that the 2 bolts at the back just below the exhaust are lose, these are for the 2 pulley's. Once you have the new belt in position feed them around the rear pulleys in an "S" shape, jack the box back into position and reattach Gear box bolts, then maneuver the pulley belts to tension the belt. Took me about an hour. Look worse than it is.
Was this answer helpful?

Rob Welbourn posted an answer 11 years, 6 months ago

0 Tried this but couldn't get the diagram from Countax - can anyone show me one?
Was this answer helpful?

Rich posted an answer 11 years, 5 months ago

0 same problem here, i bought a manual but it dosent show the belt diagram, searched every where for one....
Was this answer helpful?

Rich posted an answer 11 years, 5 months ago

0 can anyone sketch the diagram?
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual