J. A. Henckels 8300i Swimming Pool User Manual


 
1
Turn on your laptop.
2
Remove the projector’s lens cover.
3
Make sure the power light
is orange and not flashing.
4
Press the Power button to turn on the projector.
S
T
A
R
T
H
E
R
E
Turn on your equipment
C
onnect the projector
to your laptop
Follow these instructions to connect the projector to your
laptop. For other setup options, see your User’s Guide.
EPSON
®
PowerLite
®
8300i
Quick Setup
1
Locate the required cables:
2
Connect the computer cable to the
Computer 1 port on the projector.
3
Connect the other end to your laptop’s video-out
or monitor port.
4
Plug in the power cord.
Power cord Computer cable
Make sure power light
is not flashing
1
If you’ve turned on your laptop and you don’t see an image, press
the Computer/DVI button on the projector to select Computer 1
as the image source.
NOTE: If you still see a blank screen or have other difficulties,
see the troubleshooting tips on the back of this sheet.
2
Adjust the sharpness, size, and height of the image:
3
If your image looks like or , you’ve placed the projector off to
one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
4
If your image looks like or , use the Keystone button to
square up the image.
Lens Shift
to adjust the
image height
Zoom
to enlarge
the image
Focus
to sharpen
the image
Adjust the image
CAUTION: Before unplugging the projector...
To shut down the projector properly
1. Press the Power button twice. Let the projector cool while
the power light flashes orange (about 45 seconds).
2. Once the light stops flashing and stays on, it’s safe to unplug
the projector.
Never unplug the projector when the power light is green or
flashing orange.
Power button
Turn over