Filter
Top Products
14 Assembly
MAN0561 (8/25/2006)
ASSEMBLY
DEALER SET-UP INSTRUCTIONS
Assembly of this Box Scraper and Rear Blade is the
responsibility of the WOODS dealer. It should be deliv-
ered to the owner completely assembled and adjusted
for normal conditions.
Complete the Check Lists on page 17 before delivering
the attachment to the customer.
The Box Scraper and Rear Blade are shipped partially
assembled. Assembly will be easier if components are
aligned and loosely assembled before tightening hard-
ware. Recommended torque values for hardware are
located on page 20.
Before dismounting power unit or performing
any service or maintenance, follow these steps:
disengage power to equipment, lower the 3-point
hitch and all raised components to the ground,
operate valve levers to release any hydraulic pres-
sure, set parking brake, stop engine, remove key,
and unfasten seat belt.
NEVER GO UNDERNEATH EQUIPMENT. Never
place any part of the body underneath equipment
or between moveable parts even when the engine
has been turned off. Hydraulic system leak-down,
hydraulic system failures, mechanical failures, or
movement of control levers can cause equipment
to drop or rotate unexpectedly and cause severe
injury or death.
• Service work does not require going under-
neath.
• Read Operator's Manual for service instruc-
tions or have service performed by a qualified
dealer.
Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate
BOX SCRAPER
Remove Components from Shipping
Configuration
1. Remove the banding that holds the box scrapers to
pallet.
2. Remove hitch pins (5) with lock washers and nuts
shown in Figure 8.
Figure 8. Shipping Configuration - Box Scraper
3. Remove bolts (10), nuts (6) and washers (7)
securing A-frame hitch.
4. Remove A-frame hitch from box scraper.
Figure 9. Remove A-Frame Hitch
from Shipping Configuration
CAUTION
5
7 6
10
5