Filter
Top Products
Maintenance 13
MAN0561 (8/25/2006)
Replacing Scarifier Tooth
1. Remove scarifier shank (1) from the scarifier bar.
2. Remove the worn tooth by driving a chisel between
the shank (1) and tooth (2) .
3. Install replacement tooth and use a punch (3) to
bend the locking tab (4) into the retaining hole on
both sides of the shank (see Figure 7).
4. Reinstall the shank (1) in the scarifier bar.
Figure 7. Scarifier Point Replacement
CLEANING BOX SCRAPER & REAR BLADE
After Each Use
● Remove large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
● Inspect machine and replace worn or damaged
parts.
● Replace any safety decals that are missing or not
readable.
Periodically or Before Extended Storage
● Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
● Remove the remainder using a low-pressure water
spray.
1. Be careful when spraying near scratched or torn
safety decals or near edges of decals as water
spray can peel decal off surface.
2. Be careful when spraying near chipped or
scratched paint as water spray can lift paint.
3. If a pressure washer is used, follow the advice
of the pressure washer manufacturer.
● Inspect machine and replace worn or damaged
parts.
● Sand down scratches and the edges of areas miss-
ing paint and coat with Woods spray paint of
matching color (purchase from your Woods
dealer).
● Replace any safety decals that are missing or not
readable (supplied free by your Woods dealer).
See Safety Decals section for location drawing.
1
4
3
2