Filter
Top Products
Operation 11
MAN0561 (8/25/2006)
OPERATING TECHNIQUES - REAR BLADE
Adjusting Top Link
Level the A-frame and boom with 3-point connecting
links and top link. Adjusting the top link length will
change the fore and aft pitch of the tool.
Lengthening the top link will cause the tool to contact
the ground with a sharper pitch and feed itself into the
ground more readily.
Position 3-point lift arm sway blocks or tighten sway
chains to eliminate side sway. Install side braces if nec-
essary.
Reversing
For most tractors, the blade may be rotated 360° with-
out unhooking from the tractor.
To rotate without unhooking, pull hitch pin assembly,
rotate to desired position, replace hitch pin assembly.
Angling
Remove hitch pin assembly.
The blade may be set 15° or 30° to the left or right for
forward grading.
Backfilling
Reverse blade for backfilling ditches or trenches (see
Reversing).
Storage
To help prevent injury caused by a falling imple-
ment, always detach on a hard level surface.
Block equipment securely for storage.
Do not climb or lean on stored equipment.
Keep children and bystanders away from stor-
age area.
Store the rear blade with the hitch lowered to the
ground or use the optional parking stand on the upper
hole (Figure 4).
Figure 4. Optional Parking Stand - Rear Blade
PRE-OPERATION CHECK LIST
(OWNER’S RESPONSIBILITY)
___ Review and follow all safety rules and safety decal
instructions, page 5 through page 8.
___ Check that equipment is properly and securely
attached to tractor.
___ Check that all safety decals are installed and in
good condition. Replace if damaged.
___ Check that all hardware is properly installed and
secured.
___ Do not allow riders.
___ Make sure tractor ROPS or ROPS cab and seat
belt are in good condition. Keep seat belt securely
fastened during operation.
___ Check that blade cutting edge is in good condition.