Filter
Top Products
Pool Pumps
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or prop-
erty damage! Retain instructions for future reference.
© 2002 Wayne Water Systems
Operating Instructions and Parts Manual Inground and Above Ground Units
To reduce the risk
of injury, do not
permit children to use this product
unless they are closely supervised at
all times.
This pump is for
use with perma-
nently installed pools. If specified, the
pump may be used with hot tubs and
spas. Do not use with storable pools.
A permanently installed pool is con-
structed in or on the ground or in a
building such that it cannot be readily
disassembled for storage. A storable
pool is constructed so that it may be
readily disassembled for storage and
reassembled to it’s original integrity.
Pump only clear water. Do
not pump flammable or
explosive fluids such as
gasoline, fuel oil, kerosene, etc. Do not
use in a flammable and/or explosive
atmosphere. Personal injury and/or
property damage could result.
All wiring must be per-
formed by a qualified elec-
trician. The pump must be
installed in compliance with all local
codes and the National Electrical Code.
2. Do not install within an outer
enclosure or beneath the skirt of
the hot tub or spa, unless so
marked.
Installation
LOCATION
Disconnect, tag and lock out
power source before
attempting to install, ser-
vice, relocate or perform any mainte-
nance.
Locate pump as close to pool/spa as
possible. Install the pump on a hard,
level surface that is dry, well ventilated
!
DANGER
!
WARNING
!
WARNING
!
CAUTION
!
WARNING
321700-001 6/02
and away from direct sunlight. The sur-
rounding area should provide protec-
tion from the elements and ample
room for maintenance and service.
Ensure the drainage will flow away
from the pump.
Above ground pool pumps are not
self-priming. If suction line valves are
installed, the pump may be located
above water level. Keep the vertical dis-
tance from the water level to a mini-
mum. Otherwise, the pump must be
located below filled water level to facil-
itate priming.
Inground pool pumps are self-prim-
ing. Mount pump below water level for
easy priming. If the pump must be
located above the filled water level,
keep the vertical distance to a mini-
mum.
GENERAL PLUMBING
SOLVENT WELD CONNECTIONS
Use rigid or flexible PVC pipe. Ensure
pipe ends are clean and free of any
flash caused by the cutting operation.
Use the proper adhesive for the type of
pipe specified.
NOTE: Use an adhesive primer to
ensure adhesive joints are secure.
Suregard P-3000 has a purple tracer to
qualify in areas where codes specify a
primer must be used.
Description
This swimming pool pump is designed for
use with permanently installed pools only.
Unpacking
After unpacking the unit, carefully
inspect for any damage that may have
occurred during transit. Check for
loose, missing or damaged parts.
Danger indicates
an imminently haz-
ardous situation which, if not avoided,
will result in death or serious injury.
Warning indicates
a potentially haz-
ardous situation which, if not avoided,
could result in death or serious injury.
Caution indicates a
potentially haz-
ardous situation which, if not avoided,
may result in minor or moderate injury.
Notice indicates
important informa-
tion, that if not followed, may cause
damage to equipment.
This manual contains information that
is very important to know and under-
stand. This information is provided for
SAFETY and to PREVENT EQUIPMENT
PROBLEMS. To help recognize this
information, observe the following:
1. Read these rules and
instructions carefully.
Failure to follow these
instructions could
cause serious bodily
injury and/or property
damage.
NOTICE
!
CAUTION
!
WARNING
!
DANGER
READ &
FOLLOW ALL
INSTRUCTIONS
SAVE THESE
INSTRUCTIONS DO
NOT DISCARD
IMPORTANT
SAFETY
INSTRUCTIONS
MANUAL
PVC - PVC Joint PVC - ABS Joint
Uni-Weld Uni-Weld
Pool-Tite 2000 Pool-Tite 2000
Suregard Flex 20 Suregard Weld
All No. 5
IPS Weld-On 705 IPS Weld-On 794
*
These recommendations are examples only
and are not intended to restrict brands
RECOMMENDED ADHESIVES*
REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.
For parts, product & service information
visit www.waynepumps.com