Filter
Top Products
4
5. If the unit should start to vibrate abnormally,
stop the engine, disconnect the spark plug
wire and prevent it from touching the spark
plug, and check immediately for the cause. Vi-
bration is generally a warning of trouble.
6. Stop the engine, disconnect the spark
plug wire and prevent it from touching the
spark plug whenever you leave the operat-
ing position, before unclogging the tines,
or when making any repairs, adjustments
or inspections.
7. Take all possible precautions when leav-
ing the machine unattended. Stop the en-
gine. Disconnect spark plug wire and
move it away from the spark plug. Move
Wheel Gear Lever to ENGAGE.
8. Before cleaning, repairing, or inspect-
ing, stop the engine and make certain all
moving parts have stopped. Disconnect
the spark plug wire and prevent it from
touching the spark plug to prevent acci-
dental starting.
9. Always keep the tiller tine hood flap
down.
10. Never use the tiller unless proper
guards, plates, or other safety protective de-
vices are in place.
11. Do not run engine in an enclosed area.
Engine exhaust contains carbon monoxide
gas, a deadly poison that is odorless, col-
orless, and tasteless.
12. Keep children and pets away.
13. Never operate the tiller under engine
power if the Wheel Gear Lever is in DIS-
ENGAGE (FREEWHEEL). In this position,
the wheels will not hold the tiller back
and the revolving tines could propel the
tiller rapidly backward, possibly causing
loss of control. Always move the Wheel
Gear Lever to ENGAGE before starting the
engine or engaging the tines⁄wheels with
the Forward Clutch or the Reverse Clutch.
14. Be aware that the tiller may unexpect-
edly bounce upward or jump backward if
the tines should strike extremely hard
packed soil, frozen ground, or buried ob-
stacles like large stones, roots, or stumps.
If in doubt about the tilling conditions, al-
ways use the following operating precau-
tions to assist you in maintaining control
of the tiller:
a. Walk behind and to one side of the
tiller, using one hand on the han-
dlebars. Relax your arm, but use a
secure hand grip.
b. Use slower engine speeds.
c. Clear the tilling area of all large
stones, roots and other debris.
d. Avoid using downward pressure on
handlebars. If need be, use slight
upward pressure to keep the tines
from digging too deeply.
e. Before contacting hard packed soil
at the end of a row, reduce engine
speed and lift handlebars to raise
tines out of the soil.
f. In an emergency, stop tines and
wheels by releasing whichever
Clutch Lever is engaged. Do not at-
tempt to restrain the tiller.
15. Do not overload the tiller’s capacity by
attempting to till too deeply at too fast a
rate.
16. Never operate the tiller at high trans-
port speeds on slippery surfaces. Look be-
hind and use care when backing up.
17. Do not operate the tiller on a slope that
is too steep for safety. When on slopes,
slow down and make sure you have good
footing. Never permit the tiller to freewheel
down slopes.
18. Never allow bystanders near the unit.
19. Only use attachments and accessories
that are approved by Garden Way Inc.
20. Use tiller attachments and accessories
when recommended.
21. Never operate the tiller without good vis-
ibility or light.
22. Never operate the tiller if you are tired, or
under the influence of alcohol, drugs or medi-
cation.
23. Operators shall not tamper with the engine-
governor settings on the machine; the governor
controls the maximum safe operating speed to
protect the engine and all moving parts from
damage caused by overspeed. Authorized ser-
vice shall be sought if a problem exists.
24. Do not touch engine parts which may be
hot from operation. Let parts cool down
25. Please remember: You can always stop the
tines and wheels by releasing the Forward
Clutch Lever or the Reverse Clutch Control
(whichever lever you have engaged) or by mov-
ing the Throttle Control Lever to STOP.
26. To load or unload the tiller, see the instruc-
tions in Section 4 of this Manual.
27. Use extreme caution when reversing or
pulling the machine towards you.
28. Start the engine carefully according to in-
structions and with feet well away from the
tines.
29. Never pick up or carry a machine while the
engine is running.
Maintenance and Storage
1. Keep the tiller, attachments and acces-
sories in safe working condition.
2. Check all nuts, bolts, and screws at fre-
quent intervals for proper tightness to be
sure the equipment is in safe working con-
dition.
3. Never store the tiller with fuel in the fuel tank
inside a building where ignition sources are
present such as hot water and space heaters,
furnaces, clothes dryers, stoves, electric mo-
tors, etc.). Allow engine to cool before storing
in any enclosure.
4. To reduce the chances of a fire hazard, keep
the engine free of grass, leaves, or excessive
grease.
5. Store gasoline in a cool, well-ventilated
area, safely away from any spark- or flame-
producing equipment. Store gasoline in an
approved container, safely away from the
reach of children.
6. Refer to the storage instructions in the
Maintenance section of this Manual and the
separate Engine Owner’s Manual for in-
structions if the tiller is to be stored for an
extended period.
7. Never perform maintenance while the en-
gine is running or the spark plug wire is
connected, except when specifically in-
structed to do so.
8. If the fuel tank has to be drained, do this
outdoors.