Snapper Walk Behing Mower Lawn Mower User Manual


  Open as PDF
of 3
 
DEALER SET-UP INSTRUCTIONS for EUROPEAN SNAPPER
21" CAST ALUMINUM REAR DISCHARGE WALK BEHIND MOWERS
This SNAPPER Walk Behind Mower uses a handle engine control bail system to kill the engine for the SAFETY
of the operator. These mowers are designed for quick set-up. The checklist on Page 3 should be filled out by
the dealer as the items are checked off and/or performed and the Consumer/Operator Product Registration card
filled out and sent to the Customer Service department at SNAPPER when completed. CAUTION: Cutting blades
are extremely sharp. Wear heavy leather gloves when handling or working with blades. Be careful to avoid
cutting yourself on sharp edges of blade.
STEP 1: Remove unit from carton and unfold handle. Do
this carefully to prevent cables from hanging up or
becoming kinked. It will be necessary to remove
cardboard isolators between the handles and knobs.
Tighten Handle Knobs securely. See Figure 1.
STEP 2: Hold blade control bail down and at the same
time, pull engine rope handle and wrap pull cord into rope
guides that are located on handles. See Figure 1.
STEP 3: Tip mower back against the upper handle to gain
access to cutting blade. Remove foam shipping block
from cutting blade. This must be removed before starting
the engine.
FIGURE 1
IMPORTANT: This mower is shipped with the recycling plug
installed. The plug must be removed if the mower is operated
with grass catcher. DO NOT start or operate this mower
without the plug or the entire grass catcher in place.
STEP 4: With grass catcher and catcher frame assembly
upside down (plastic bottom turned up), insert bag frame
assembly into catcher as shown in Figure 2. Fasten "C"
shaped plastic edge strip located on front of bag around
frame assembly on all four sides. Make sure edge strip is
fastened securely.
FIGURE 2
STEP 5: Install grass catcher to mower as follows: Lift
discharge door, then grasp handle and hold grass
catcher/frame up while placing rod ends over tabs at rear
of mower deck. Release discharge door. See Figure 3.
FIGURE 3
INSTRUCTION No. 7-3088 (REV. 1, 8/24/01)
BLADE CONTROL
WHEEL DRIVE
CONTROL
ROD
ENDS
DISCHARGE DOOR
TABS
GRASS CATCHER
BOTTOM OF
GRASS
CATCHER
CATCHER
HANDLE
SLIDE FRAME ALL
THE WAY INTO
GRASS CATCHER
EDGE STRIPS:
ATTACH STRIPS TO
FRAME.
CABLE CLIPS
UPPER
ROPE
GUIDE
LOWER
ROPE
GUIDE
CURVED HEAD
BOLTS
ENGINE
ROPE
next