SkyLink 91562-01 Garage Door Opener User Manual


 
-J02028 REV. 2010-09-07
REMOTE CONTROL GARAGE DOOR OPENER KITS
GENERAL
Kit Numbers
91558-01A (Transmitter/Receiver Kit), 91561-01 (Transmitter
Kit), 91562-01 (Receiver Kit)
Models
For model fitment information, see the P&A retail catalog or
the Parts and Accessories section of www.harley-davidson.com
(English only).
Additional Parts Required
2011 and later Softail models will require separate purchase
of an Electrical Connection Harness (Part No. 72673-11).
Tools and Supplies Required
Electrical Contact Lube (Part No. 99861-02) or equivalent is
required after battery cable disconnection.This item is available
from a Harley-Davidson dealer.
The rider's safety depends upon the correct installation
of this kit. Use the appropriate service manual procedures.
If the procedure is not within your capabilities or you do
not have the correct tools, have a Harley-Davidson dealer
perform the installation. Improper installation of this kit
could result in death or serious injury. (00333a)
NOTE
This instruction sheet refers to service manual information. A
service manual for this year/model motorcycle is required for
this installation and is available from a Harley-Davidson dealer.
Electrical Overload
It is possible to overload your vehicle's charging system
by adding too many electrical accessories. If the combined
electrical accessories operating at any one time consume
more electrical current than the vehicle's charging system
can produce, the electrical consumption can discharge
the battery and cause damage to the vehicle's electrical
system. See an authorized Harley-Davidson dealer for
advice about the amount of current consumed by addi-
tional electrical accessories or for necessary wiring
changes. (00211c)
When installing any electrical accessory, be certain not
to exceed the maximum amperage rating of the fuse or
circuit breaker protecting the affected circuit being modi-
fied. Exceeding the maximum amperage can lead to elec-
trical failures, which could result in death or serious injury.
(00310a)
The Remote Control Transmitter in kits 91558-01A and 91561-
01 requires up to 0.5 Amps additional current from the electrical
system.
Kit Contents
See Figure 27, Table 1, Table 2 and Table 3.
FCC NOTICES
NOTE
Changes or modifications to this unit not expressly approved
by the manufacturer could void the user's authority to operate
the equipment.
This equipment has been tested and found to comply with the
limits for Class B digital devices pursuant to Part 15, Subpart
B of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a resid-
ential environment.This equipment generates, uses, and can
radiate radio-frequency energy, and if not installed and used
in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Re-orient or relocate the receiving antenna.
Increase the distance between the equipment and the
receiver.
Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
-J02028 1 of 16