Filter
Top Products
10” HEAVY
DUTY PLOW
NOTE: REPOSITION BEAM END TO THESE HOLES, WHEN
USING PLOW WITH 2-WHEEL TRACTORS.
,~fgM
’
the plow is used
H
rith the
“725”,
move the Beam End to the center
of the
Plow Beam Assembly after moving the
Spacer(“A”)
to outside of Beam Assem-
b/y, opposite of Spacer
“B”
MODEL 725 RIDING TRACTOR
LANDLORD RIDING TRACTOR
ASSEMBLY AND ADJUSTMENT
(
REQUIRES
#203
HITCH ADAPTER )
1. Remove varnish from moldboard and share, using
a good grade of varnish remover. (Keep greased when
not in use.
)
CAUTION: Be sure that the rolling, coulter is out of
the ground when the tractor is in reverse gear.
2. Bolt standard ( 1
)
to plow bottom
(
2
)
.
3. Bolt beam
(
3
)
to standard at
(
4
)
. Lock with jam
nut so that beam
is
free to swing on standard.
4. Attach depth regulating yoke rod assembly
(
5
).
Pin and cotter pin.
6. Attach the lift pin and chain assembly ( 9 ) to the
beam at
(
8
)
by means of the pin and spring clip pro-
vided. The hitch
clevis
adapter
(
10
)
is then
attach-
ed to the tractor hitch by means of the pivot pin.
Connect
the plow to the hitch adapter with the hitch
pin and insert the lift pin
(
9 ) In the tractor rear lift
assembly and secure in place with a pin and s,pring
clip.
5. Attach rolling coulter assembly
(
6
)
and adjust
coulter standard
(
7 ) so that blade runs approximately
7. Wheel weights should be used when operating the
l/2”
to the left of landslide. Set the rolling coulter
10” Plow. The weights are designed so that as many
for best depth depending upon the soil.
weights as necessary may be added to the wheels
Lie,. in
USA
S,MPL,C,TY
MANUFACTURING COMPANY,
INC.