Filter
Top Products
SHARK SSG • 97-6134 • REV. 7/05a
9
PRESSURE WASHER
OPERATOR’S MANUAL
OPERATING INSTRUCTIONS
STEP 8: Pull the starter grip. If the engine fails to start
after 2 pulls, squeeze the trigger gun to release pres-
sure and repeat step. Return starter gently. After the
engine warms up enough to run smoothly, move choke
to run position and throttle to fast position.
CAUTION: Small engines may kick back. Do not hold
pull starter grip tightly in hand.
WARNING! Never replace
nozzles without engaging the
safety latch on the spray gun
trigger.
The four color-coded quick connect
nozzles provide a wide array of spray
widths from 0° to 45° and are easily
accessible when placed in the con-
venient rubber nozzle holder, which
is provided on the front of the ma-
chine.
NOTE: For a more gentle rinse, se-
lect the white 40° or green 25° nozzle.
To scour the surface, select the yel-
low 15° or red 0° nozzle. To apply de-
tergent select the black nozzle.
NOZZLES
Safety
Latch
STEP 9: Turn the burner “ON”. Turn temperature con-
trol dial to the 210° mark.
Burner
Temperature
Control
STEAM COMBINATION
Thermostat
Step 1: For steam, open the steam
valve counterclockwise.
This lowers the pressure and raises
the temperature.
Step 2: Turn the thermostat knob to
the 270° mark, (The thermostat is a
high limit device and does not regu-
late temperature.
Step 3: To stop, reverse steps. Set
all controls to their original settings.
Step 4: Turn burner switch off, open
trigger on spray gun and allow water
to cool.
Burner Switch
Steam Valve