Saunatec 1108-60 Hot Tub User Manual


 
Installation & Operation Instructions
4211-86-G 09-23-05
1
314 SKLH 20C
SAUNA HEATER 1108-24, 1108-46 & 1108-60
Saunatonttu 2.4, 4.6, & 6.0 kW
Read all instructions carefully before installation.
Please leave all instructions with the owner.
WARNING
Prolonged exposure to elevated temperatures is capable of inducing
hyperthermia. Hyperthermia occurs when the internal temperature of
the body reaches several degrees above the normal body temperature
of 98.6°F. The symptoms of hyperthermia include an increase in the
normal temperature of the body, dizziness, lethargy, drowsiness, and
fainting. The effects of the hyperthermia include failure to perceive
heat, failure to recognize the need to exit the room, unawareness of
impending hazard, fetal damage in pregnant women, physical inability
to exit the room and unconsciousness.
WARNING
The use of alcohol, drugs, or medication is capable of greatly increas-
ing the risk of fatal hyperthermia.
SECTION 1: GENERAL INFORMATION
Do not take a sauna if using
alcohol, drugs or medications.
Pregnant women or persons
with poor health should
consult their physician before
using any sauna.
Caution fire hazard: Do not
use the sauna room for drying
clothes, bathing suits, etc. Do
not hang towels above heater
or place any object, other than
the rocks supplied, on the
heater. If any darkening of
the wall around the heater is
noticed discontinue sauna use
immediately.
Inspect sauna regularly for
required maintenance to
heater, control and benches.
Replace wood surfaces which
show any signs of deteriora-
tion.
The heater opening gets
extremely hot during opera-
tion.
Keep clear of opening while
sprinkling water on the rocks.
Steam is very hot and forceful.
Close heater lid after use.
Minors should be adequately
supervised whenever near a
hot or warming sauna.
Warning
Note: Saunatonttu users: Please read “Section 6” to understand the
principles around which this heater is designed, and to understand the
sauna conditions it will create for you.
These heaters are UL approved for permanent installations and electrical
connections. Built with splash proof construction, the conducting parts
are protected against water. All wiring must be performed in accordance
with local codes. See Diagram 2 for wiring and room size requirements.