Filter
Top Products
7
7. Adjust the strap, allowing the hook to be
about 3 -- 6 inches below the waist.
8. Fasten the strap hook to the upperclamp
and lift the tool to the operating position.
Shoulder Strap
Shoulder
Strap
Clamp
ADJUSTING THE ASSIST HANDLE
WARNING: When adjusting the as-
sist handle, be sure it remains directly above
the coupler onthe engine endshaft to ensure
proper balancing of unit.
Assist Handle
Coupler
OPERATION
KNOW YOUR PRUNER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERA T ING YOUR
PRUNER A TT ACHMENT. Compare the illustrations with your attachment to familiarize yourself with
the location o f the various c ontrols and adjustments. Save this manua l for fu ture reference.
Shaft
Coupler
Pruner
Chain
Bar
Bar oil fill cap
B
a
r
n
u
t
Hanger
PRUNER
The PRUNER is designed for removal of
limbs and branches overhead not greater
than 4 inches in diameter.
CHAIN TENSION
It is normal for a new c hain to stretch during
first 15 minutes of operation. You should
check your chain tension frequently. See
CHAIN TENSION in theSERVICE AND AD-
JUSTMENTS section.
OPERATING THE COUPLER
Your pow erhead is equippe d w ith a coupler
which enables optional attachments to be
installed. The optional attachments are:
MODEL:
Edger PP1000E.......................
Cultivator PP2000T....................
Blower PP3000B......................
Brushcutter PP4000C..................
WARNING: Always disconnect pow-
erhead spark plug (or disconnect powerhead
frompowersource) beforeremoving orinstal-
ling attachments.
REMOVING PRUNER ATTACHMENT
(OR OTHER OPT IONAL ATTACH-
MENTS)
CAUTION:
When removing or installing at-
tachments, place the powerhead and attach-
ment on a flat surface for stability.
1. Loosen the coupler by turning the knob
counterclockwise.