Poulan 966423701 Pole Saw User Manual


 
15
S Keep shoulder strap pad centered on your
left shoulder and danger sign centered on
your back.
S Maintain full weight of tool on your left
shoulder.
Always release the throttle trigger and allow the
engine to return to idle speed when not pruning.
To stop engine:
S Release the throttle trigger.
S Push and release the engine ON/STOP
swit ch.
PRUNING
WARNING: Be alert for and guard
against kickback. Do notallowthe m ovingchain
to contact any other branches or objects at the
nose of the guide bar when pruning. Allowing
such contact can result in serious injury.
IMPORTANT POINTS
S W ork slowly, keeping both hands firmly
gripped on the pruner. Maintain secure
footing and balance.
S Plan cut carefully . Check direction branch
will fall.
S Watch out for springpoles. Springpoles are
small size limbs which can catch t he chain
and whip toward you or pull you off balance.
Use extreme caution when cutting small size
limbs or slender material.
S Watch out for branches immediately behind
the branch being pruned. If the chain hits the
rear branch, damage to the unit may occur .
S Be alert for springback. Watch out for
branches that are bent or under pressure.
Avoid being struck by the branch or the
pruner when the tension in the wood fibers
is released.
S Keep a clear work area. Frequently clear
branches out of the way to avoid tripping
over them.
S Long branches should be removed in
several pieces.
PRUNING TECHNIQUE
When ready to cut, accelerate to full throttle
and apply a light cutting pressure. DO NOT
use back and forth sawing action.
Pruning technique
Second cut
Third cut
Collar
First cut
1. M ake the first cut 6 inches (15 cm) from
the tree trunk on the bottom of the limb.
Usetopof guidebar tomake thiscut. Cut
1/3 through the diameter of the limb.
NOTE: When making the second and third
cuts, rest the foot of the p runer against the
tree limbthat is b eing cut to prevent whipping
of the branch.
Foot
2. Next, move 2 -- 4 inches (5 -- 10 cm) far-
ther out on the limb and make a second
cut all the way through the limb.
3. Then,makea finalcutleavinga 1-- 2inch
(2.5 -- 5 cm) collar f rom the trunk of the
tree to avoid damage to the tree.
OPERAT ING INSTRUCTIONS FOR
TRIMMER ATTACHMENT
OPERATING POSITION
Eye protection
Long pants
Heavy shoes
ALWAYS WEAR:
Cut from your right to your left.
WARNING: Alwaysweareyeprotec-
tion. Never lean over the trimmer head.
Rocks ordebris canricochetorbethrowninto
eyes and face and cause blindness or other
serious injury .
Do not run the engine at a higher speed than
necessary. The cutting line will cut efficiently
whentheengineis runatlessthan fullthrottle.
At lower speeds, there is less engine noise
and vibration. The cutting line will last longer
and will beless likely to“weld” ontothespool.
Always release the throttle trigger and allow
the engine to return to idle speed when not
cutting.
To stop engine:
S Release the throttle trigger.
S Push and release the engine ON/STOP
switch.