Filter
Top Products
13
S During light duty cutting.
S Near objects around which the line can
wrap such as small posts, trees or fence
wire .
S F or mowingor sweeping, use fullthrottlefor
a good clean job.
TRIMMING -- Hold the bottom of the trimmer
head about3 inches (8cm) abovethe ground
andatan angle.Allowonly thetipof thelineto
make contact. Do not force trimmer line into
work area.
Trimming
3 inches (8 cm)
above ground
SCALPING -- The scalping t echnique re-
moves unwanted vegetation down to the
ground. Hold the bottom of the trimmer head
about 3 inches (8 cm) above the ground and
atanangle.Allowthetipofthelinetostrikethe
ground around trees, posts, monuments, etc.
This technique increases line wear.
Scalping
MOWING -- Your trimmer is idea l for mowing
in places conventional lawn mowers cannot
reach. In the mowing position, keep the line
parallel to the ground. Avoid pressing the
head into the ground as this can scalp the
ground and damage the tool.
Mowing
SWEEPING -- Thefanning actionof therotat-
ing line can be used for a quick and easy
clean up. Keep the line parallel to and above
the surfaces being swept and move the tool
from side to side.
Sweeping
MAINTENANCE
WARNING: Disconnect the spark
plug before performing maintenance e xcept
for carburetor adjustments.
HELPFUL TIP
IMPORT ANT: Have all
repairs other than the rec-
ommended maintenance
described in the instruction
manual performed by an
authorized service dealer .
If any dealer other than an authorized
service dealer performs work on the
product, Poulan PRO may not pay for
repairs under warranty. It is your re-
sponsibility to ma intain and perform
general maintenance.
CHECK F OR LOOSE
FASTENERS AND PARTS
S Spark Plug Boot
S Air Filter
S Housing Screws
S Assist Handle Screw
S Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re-
placement of damaged or worn parts.
S ON/STOP Switch -- Ensure ON/STOP
switch functions properly by pushing and
releasing the switch. Make sure engine
stops. Wait5 secondsbefore attemptingto
restart unit to allow switch to reset. Restart
engine and continue.
S Fuel Tank -- Discontinue use of unit if fuel
tank shows signs of damage or leaks.
S Debris Shield -- Discontinue use of unit if
debris shield is damaged.
INSPECT AND CLEAN UNIT AND
LABELS
S After each use, inspect complete unit for
looseor damagedparts. Cleantheunit and
labels using adamp cloth witha mild deter-
gent.
S Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine perform-
ance and increases fuel consumption and
harmful em issions. Always clean after every
5 hours of operation.
1. Cleanthe cover and the area around itto
keep dirt from falling into the carburetor
chamber when the cover is removed.
2. Loo sen knob by t urning counterclock-
wise. Remove air filter cover and air filter .
NOTE: To avoid creating a fire hazard or
producingharmful evaporative em issions,do
not clean filter in gasoline or other flammable
solvent.
3. Wash the filter in soap and water.
4. Allo w filter to dry.
5. Replace parts.