Filter
Top Products
14- ENG
D25115
NOTE: Water source must provide
a minimum of 5 gallons per minute
at 20 p.s.i.
6. If you are applying a chemical or
cleaning solution, See How To
Siphon Chemicals/Cleaning
Solvents in Operation section of
this manual.
7. Turn water source on.
NOTE: Make sure water supply is
turned on.
8. Start engine, refer to engine
manual for correct procedure.
If the engine does
not start after two
pulls, pull the trigger to relieve the
pressure.
9. Depress trigger on gun to start
water flow. Release trigger to
stop water flow.
10. Adjust nozzle spray for the task
being performed. See How To
Use Wand instructions in this
section.
DO NOT let hoses
come in contact
with very hot engine muffler during
or immediately after use of your
pressure washer.
• Never turn water supply off
while pressure washer engine
is running or damage to pump
will result.
• DO NOT use hot water, use
cold water only.
• DO NOT stop spraying water
for more than two minutes at a
time.
1. Add fresh high quality unleaded
gasoline with a pump octane rat-
ing of 86 or higher. Do not over-
fill. Wipe up spilled fuel before
starting the engine. Refer to
engine manual for correct proce-
dure.
2. Check engine oil. Refer to the
engine manual for correct proce-
dure.
NOTE: There will be a slight
amount of oil in the engine form
factory tiesting.
3. Verify the filter screen is in water
inlet of pump, as shown.
4. Connect high pressure hose to
pump outlet.
5. Connect water source to pump
inlet.
Water
Source
High
Pressure
Hose
Filter Screen