Filter
Top Products
LOW VOLTAGE WlHlNti UlAGHAM
OPERATING INSTRUCTIONS
I I I
0 0 0
n k k k
ZZZZ
ommm
tttt
XOJZ
JWW(1:
m
(1:
+
0
I I I
-~m
000
nkkk
aaa
ZZZZ
r55p
ommm
<<<N
JJJ
+
tttt
X3XZ
dJJ(1:
tttt
xkxn
-I
I
-I
w
mmmo m3mrr
Do not untwist pairs.
It is neccessary to retain
wires in pairs so that
appropriate connections
can be identified.
-
N
(1:
LA
:I
I
Ell
HIGH VOLTAGE
RELAYS
R6
R7
GENERAL CONTROL FEATURES
FILTER PUMP OFF DELAY. This causes the filter pump to run an additional
4
minutes every time it is turned off. The purpose of this is to protect the gas heater
and plumbing from possible scale build-up and thermal stress. These occur when
residual heat in the gas heater is not allowed to dissipate after heater is turned off.
POOLCLEANER ON DELAY. Every time the pool cleaner pump is turned on, this
circuit prevents it from running until
4
minutes have passed. This protects the
pump from damage caused by air in the water lines that may have entered into
the plumbing since it was last used.
TIME CONTROL
EQUIPMENT BUlTON FUNCTIONS:
FILTER:
Turns filter pump ON and circulates POOL water.
CLN R:
Turns filter and cleaner pumps ON. (Cleaner delayed
4
minutes)
SPA:
Turns filter pump ON and circulates
SPAwater. Allows heater to
operate. Overrides CLNR key and turns pool cleaner pump OFF,
even
if
CLNR "flag" is present.
AUX1:
Turns electrically controlled function ON. (lights, jets, etc.)
TEMPERATURE CONTROL
WATER TEMPERATURE Display:
Pool temperature is displayed when the pool is operating, spa temperature when
the spa is operating. If filter pump is off, display may be meaningless
THERMOSTAT:
Desired pool or spa temperature is set here.
HEATER CONTROL
SWITCH POSITIONS:
PO
0
L:
Allows heating of pool to the preset temperature level.
SPA:
Allows heating of spa to the preset temperature level.
OFF: Allows no heating.
HEATER ON Light:
When lit, indicates that heater is on.
STATUS DISPLAY
The presence of a light next to an equipment label indicates that it is ON. The
absence of a light indicates OFF.
DELAY CANCEL
BUlTON FUNCTIONS:
FILTER: To override the Filter Delay Circuit, press CANCEL OFF DELAY
button. Provided that there is no "flag" present at either
FILTER, CLNR or SPA buttons, the filter pump will shut off
immediately.
CLNR: To override the Cleaner Delay Circuit, press CANCEL ON
DELAY button. Provided that there is a "flag" present at the
CLNR button, the pool cleaner pump will start immediately.
If SPA is on, CLNR is inoperative.