Northern Industrial Tools M1107C Log Splitter User Manual


 
Periodic Maintenance
2626
In addition to the maintenance performed with each use, periodic maintenance should also be performed
according to the following schedule.
WARNING
AWAYS shut off the engine, disconnect the spark plug, and relieve system pressure before cleaning, adjusting, or
repairing the splitter. Relieve system pressure by moving Split Control Lever back and forth several times.
IMPORTANT:
If a part needs replacement only use parts that meets the manufacturer’s specifications. Replacement parts that do
not meet specifications may result in a safety hazard or poor operation of the log splitter.
1. Engine
maintenance
As specified in
engine manual
Perform engine maintenance as specified in engine owner’s manual.
2. Hydraulic
Oil Change
Annually / 100
hours
Change Hydraulic Oil.
WARNING: High fluid pressures and temperatures are developed in
hydraulic log splitters. Hydraulic fluid escaping through a pin hole sized
opening can burn or puncture skin, resulting in wounds that could cause
blood poisoning, infection, disability, gangrene, amputation, or death.
Therefore, the following instructions should be heeded at all times when
inspecting or servicing the hydraulic components of the log splitter.
NEVER check for leaks with your hand. Leaks can be located by holding a
piece of cardboard or wood (at least two feet long) with your hand at one
end and passing the other end over the suspected area (wear eye protection).
Look for discoloration of the cardboard or wood.
NEVER adjust the pressure of the pump or valve.
If injured by escaping fluid, no matter how small the wound is, see a doctor
at once. A typical injection injury may be a small wound that does not look
serious. However, severe infection or reaction can result if proper medical
treatment is not administered immediately by a doctor who is familiar with
injection injuries.
1. Use 10wt AW32, ASLE H-150, or ISO32 oil.
2. Relieve hydraulic system pressure by moving Split Control Lever back
and forth several times.
3. Remove hydraulic oil fill cap.
WARNING: NEVER remove the hydraulic oil fill cap when the engine
is running or hot. Hot oil can escape causing severe burns. Allow the log
splitter to cool completely before removing hydraulic oil fill cap.
4. Remove the suction hose from the hydraulic tank to drain the hydraulic
oil.
5. Fill to 1” from top of hydraulic tank with cylinder retracted.
6. Dispose of used oil at an oil recycling center. Used hydraulic oil is
hazardous waste.
3. Spark
arrestor
muffler
As specified in
spark arrestor
muffler manual
If the engine is equipped with a spark arrestor muffler, clean and inspect it
regularly (follow manufacturer’s service instructions). Replace if damaged.