Nilfisk-Advance America 56316025 (R32-C) Lawn Sweeper User Manual


 
A-14 / ENGLISH
A-14 - 56041647 - Adhancer
R28-C, R32-C / BR 800S TRIO EDS
CHARGING THE BATTERIES
Charge the batteries each time the machine is used, or whenever the Battery Condition Meter (K) is showing a yellow, red or ashing red indicator light(s).
WARNING !
Do not ll the batteries before charging.
Only charge batteries in a well-ventilated area.
Do not smoke while servicing the batteries.
When Servicing Batteries...
Remove all jewelry.
Do not smoke.
Wear safety glasses, a rubber apron and rubber gloves.
Work in a well-ventilated area.
Do not allow tools to touch more than one battery terminal at a time.
To Charge the Batteries...
1 Depress the Battery Disconnect (13).
2 Open the Battery Compartment Cover (16) to provide proper ventilation.
3 Push the connector from the Battery Connector (22) into the charger connector (Connector (29) if equipped with an onboard charger). Plug the AC line cord
into a properly grounded wall outlet.
4 Follow the instructions on the battery charger.
5 Check the uid level in all battery cells after charging the batteries. Add distilled water, if necessary, to bring the uid level up to the bottom of the ller tubes.
CAUTION !
To avoid damage to oor surfaces, always wipe water and acid from the top of the batteries after charging.
CHECKING THE BATTERY ELECTROLYTE LEVEL
Check the electrolyte level of the batteries at least once a week.
After charging the batteries, remove the vent caps and check the electrolyte level in each battery cell. Use distilled water to ll the batteries to the bottom of the
ller tube.
Do not over- ll the batteries!
CAUTION !
Acid can spill onto the oor if the batteries are over lled.
Tighten the vent caps. If there is acid on the batteries, wash the tops of the batteries with a solution of baking soda and water (2 tablespoons of baking soda to 1
quart of water).