Nilfisk-Advance America 56316025 (R32-C) Lawn Sweeper User Manual


 
A-10 / ENGLISH
A-10 - 56041647 - Adhancer
R28-C, R32-C / BR 800S TRIO EDS
DETERGENT SYSTEM PREPARATION AND USE
COMMON INSTRUCTIONS:
The system should be purged of previous detergent when switching to a different
detergent. SERVICE NOTE: Move machine over oor drain before purging because a
small amount of detergent will be dispensed in the process.
To Purge When Changing Chemicals:
1 Disconnect and remove the detergent cartridge.
2 Turn the Key Switch (J) ON and press the Detergent ON/OFF Switch (S) and the
Flow Rate Switch (T) down for at least 3 seconds. NOTE: Once activated the
Flow Rate Indicator (U) will begin to ash and will automatically shut off after 10
seconds. Normally one purge cycle is adequate to purge the system.
To Purge Weekly:
1 Disconnect and remove the detergent cartridge. Install and connect a Cartridge
lled with clean water
2 Turn the Key Switch (J) ON and press the Detergent ON/OFF Switch (S) and the
Flow Rate Switch (T) down for at least 3 seconds. NOTE: Once activated the
Flow Rate Indicator (U) will begin to ash and will automatically shut off after 10
seconds. Normally one purge cycle is adequate to purge the system.
The Detergent Box (AA) has a Detergent Level Viewing Slot (BB) for keeping
track of how much detergent is remaining in the cartridge. When the detergent
level is nearing the bottom of this slot it is time to re ll or replace the cartridge.
General Use:
The detergent (AXP/EDS) system is turned on when the Key Switch (J) is
turned on but no detergent is dispensed until the scrub system is activated
and the Drive Pedal (8) pushed forward. The solution ow rate automatically
defaults to the last setting used. The solution ow rate can be varied by
subsequently pressing the Flow Rate Switch (T). There are two solution
ow rates indicated by the Flow Rate Indicator (U). The detergent ow rate
increases or decreases with the solution ow rate but the detergent ratio
remains the same. During scrubbing, the detergent system can be turned off
at any time by pressing the Detergent ON/OFF Switch (S) to allow scrubbing
with water only. The solution ow rate is controlled by the Flow Rate Switch (T)
whether the detergent system is ON or OFF.
SERVICE NOTE: Follow the “To Purge Weekly” instructions above if the
machine is going to be stored for an extended period of time or if you plan to
discontinue use of the detergent (AXP/EDS) system.
NON-REFILLABLE CARTRIDGE SPECIFIC INSTRUCTIONS:
Remove the Cap (CC) and place the cartridge in the detergent box. Install the
Dry Break Cap (DD) as shown.
REFILLABLE CARTRIDGE SPECIFIC INSTRUCTIONS:
Fill the detergent cartridge with a maximum of 1.25 gallons (4.73 Liters)
of detergent. SERVICE NOTE: Remove the detergent cartridge from the
detergent box prior to lling to avoid spilling detergent on the machine.
It is recommended that a separate cartridge be used for each detergent you
plan to use. The detergent cartridges have a white decal on them so you can
write the detergent name on each cartridge to avoid mixing them up. The
detergent cartridge has a Magnetic Slider (EE) on one end that needs to be
set to the proper dilution ratio according to the dilution instructions on the
manufacturer’s bottle. Slide the Magnet Slider (EE) to the appropriate location
on Detergent Dilution Ratio Decal (FF). When installing a new cartridge,
remove the Cap (CC) and place the cartridge in the detergent box. Install the
Dry Break Cap (DD) as shown.