Filter
Top Products
New Holland
Forage Blower Specifications
F62B
Page 1of 1
MODEL F62B
LENGTH 108 in. (2,743 mm)
WIDTH 100 in. (2,540 mm)
WEIGHT 1,605 lbs. (729 kg)
BLOWER
Blowing height* Over 100 ft. (Over 30 m)
Blower housing 60 in. dia. (1,524 mm)
Paddles (adjustable) 8
Paddle tip speed 8,460 ft./min. (2,579 m/min.)
Drive Direct PTO
HOPPER
Diameter Auger–12 in. (305 mm)
Length Auger–50 in. (1,270 mm)
Width 37 in. (940 mm)
Height from ground Adjustable–20
1
⁄
2
in. (520 mm)
to 27
1
⁄
8
in. (699 mm)
Feeder type Auger
DRIVELINE PROTECTION Shearbolt
PTO 540 rpm
TIRES 4.80–8 “C” load range
CAPACITY (with adequate power)
Corn silage* Up to 180 tons/hr. (163 mt/hr.)
Haylage* Up to 110 tons/hr. (100 mt/hr.)
OPTIONAL EQUIPMENT Pipe Clamp
Kwik Pipe Bundle
Telescoping Pipe Section
Hinged Deflector
Safety Tow Chain+
* Capacity and height will depend upon tractor horsepower, type of crop, moisture content, length of cut, as well as general maintenance of pipes and spout.
+ Available from New Holland Service Parts.
Safety begins with a thorough understanding of
the equipment. Always make sure you and
your operators read the Operator’s Manual
before using the equipment. Pay close
attention to all safety and operating
decals and never operate machinery
without all shields, protective devices
and structures in place.
Design, materials and/or specifications are subject to
change without notice and without liability therefor.
Specifications are applicable to units sold in Canada, the
United States, its territories and possessions, and may
vary outside these areas.
© 2008 CNH America LLC
New Holland is aregistered trademark of CNH America LLC.
Visit our Web site at www.newholland.com/na. Or, call toll-free 866-NEW-HLND (866-639-4563).