MTD 31AH553G401 Snow Blower User Manual


 
8
Traction Drive/Auger Clutch Lock
The traction drive clutch is located on the right handle.
Squeeze the traction drive clutch to engage the wheel
drive. Release to stop.
This same lever also locks the auger clutch to avoid
interruption of the snow throwing process. If the auger
drive clutch is engaged with the traction drive clutch
engaged, the operator can release the auger drive
clutch (on the left handle) and the augers will remain
engaged. Release the traction drive clutch to stop both
the augers and wheel drive (auger drive clutch must
also be released).
Headlight
The headlight is on whenever the engine is running.
Safety Ignition Switch
The ignition key must be inserted completely in the
switch before the unit will start. Do not attempt to turn
the key.
Fuel Shut-Off Valve
The fuel shut-off valve, located under the fuel tank,
controls fuel flow from tank. Make sure it is not turned
off before starting the engine.
Electric Chute Rotation Switch
The electric chute-rotation switch is located on the left
side of the snow thrower dash panel.To change the
direction in which discharged snow is thrown, proceed
as follows:
Push the toggle switch to the left to rotate the chute
counter-clockwise.
Push the toggle switch to the right to rotate the
chute clockwise.
IMPORTANT:
Release the switch once the chute has
completed its rotation cycle in either direction. Failure to
do so can result in damage to the electric chute motor
and/or its drive gear.
Chute Tilt Control
The distance snow is thrown can be adjusted by
adjusting the angle of the chute assembly. Move the
chute tilt control forward to decrease the distance, and
towards the rear to increase the distance.
Stay Warm Handles Switch
This switch is located on the right side of the snow
thrower dash panel. To activate the Stay Warm
handles, toggle the switch to the right to generate heat
within the handle grips. Toggle the switch to the left to
the OFF position after using the snow thrower.
NOTE: The Stay Warm grips are a compliment to, not a
substitute for, proper cold weather outerwear for the
operator’s hands. It is recommended that the snow
thrower operator wear gloves/mittens to avoid
extremities of winter while operating this equipment.
To Stop Engine
CAUTION: If for some reason, the unit starts
accidentally while the operator is getting aquainted with
the controls listed above, stop the engine immediately.
To stop engine, push the throttle lever all the way
down, or remove the ignition key. Do not turn key.