Filter
Top Products
Stop the engine and disconnect the spark plug lead before working on the machine. DO NOT TIP
THE MOWER FORWARD OR ONTO ITS SIDE AS THIS WILL FLOOD THE CYLINDER AND AIR FILTER
WITH OIL. To access the underside of the machine, lift the front wheels by lowering the handle
until it rests on the ground.
CUTTER BLADE
Examine the cutter blade regularly for wear or damage.
• A slightly worn blade can be re-sharpened by your local dealer.
• If the blade is damaged it should be replaced. Replacement blade kits
are available from your Mountfield stockist. If in doubt refer to your
dealer, or telephone 0845 600 2912.
CLUTCH (Figure 8)
• Once or twice a year clean the area around the transmission and drive
belt.
• Remove the guard (1) by unscrewing the screws (2) and releasing the
couplings (3).
• Using a brush or compressed air carefully remove any grass and dirt
from aound the transmission and drive belt.
• Always refit the guard (1).
ENGINE
An engine manufacturer’s Owner’s Manual is supplied with your mower.
Please read this, it provides detailed information on engine operation,
maintenance and battery care. Repair work other than routine maintenance,
should be carried out by an authorised dealer.
STORAGE
A little time spent on your mower after use will ensure many years of reliable mowing. To access the underside of the
cutter deck, ensure the spark plug lead is disconnected, then lift the front wheels by lowering the handle until it rests
on the ground. Do not tip the mower onto its side, as this will flood the air filter with oil.
AFTER EACH USE
• Remove any grass pulp from the underside of the cutter deck using a non-metallic instrument such as a piece of
wood. Take care not to damage the paintwork.
• Examine the cutter blade for any damage. A damaged blade may upset the balance of your mower and cause
excessive vibration, if in doubt refer to your dealer.
• The upper handle can be removed and folded down to reduce the amount of storage space required. Take care
not to trap any of the operating cables when removing or refitting the handle.
• Store the mower in a clean, dry area well away from any naked flames, sparks or heat source.
LONG TERM - If you are not using your mower for more than 28 days.
• Give the machine a thorough clean, paying particular attention to the underside of the cutter deck.
• Lubricate all moving parts.
• At the end of the season, empty the fuel tank either by running the mower out of fuel or tip the machine backwards
and onto the back right wheel to drain the fuel into a suitable container. Drain the carburettor by loosening the
drain screw, retighten the drain screw.
MAINTENANCE
Figure 8
Figure 7
BEFORE EACH USE
• Always ensure that the mower is in a safe working condition. Inspect the cutter blade for damage; check safety
devices and guards; check that all nuts, bolts and screws are secure.
• Check the oil level as follows:
a) Remove the oil filler cap and wipe the dipstick clean (Figure 7).
b) Insert the dipstick into the filler neck and tighten down again.
Remove the dipstick and check the oil level; oil should be at the MAX
mark. The oil tank capacity is about 0.55 litre or 18 fluid oz.
c) If the oil level is low add Mountfield oil part number MX855 or a
SAE 10W-30 oil, to the upper limit on the dipstick. Do not overfill; the
oil level should not be above the FULL mark.
• Fill the fuel tank with unleaded petrol. Do not overfill; the level should
be below the bottom of the fuel tank neck.