Filter
Top Products
12
S As you move forward to the next area to cut,
be sure to m aintain your balance and f ooting.
Cut using the 2
o’clock to 4 o’clock
position of the
blade
2 o’clock
4 o’clock
RECOMMENDED CUTTING POSITION
WARNING: The operator or others
mustnott rytoclearawaycutmaterialwiththe
engine running or the blade turning to avoid
serious injury. Stop engine and blade before
removingmaterials wrappedaround bladeor
shaft.
MAINTENANCE
The life span of the machine can bereduced
and the risk of accidents can increase if ma-
chinemaintenanceisnotcarriedoutcorrectly
and if service and/or repairs are not carried
out professionally . If you need further infor-
mation, please contact your nearest autho-
rised service dealer.
WARNING: Disconnect the spark
plug before performing maintenance except
for carburetor adjustments.
CHECK FOR LOOSE
FA STENERS AND PARTS
S Spark Plug Boot
S Air Filter
S Housing Screws
S Handlebar Screws
S Combination Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re-
placement of damaged or worn parts.
S ON/STOP(I/0)Switch -- EnsureON/STOP
(I/0) switch functions properly by m oving
the switch to the STOP (0) position. Make
sure engine stops; then restart engine and
continue.
S Fuel Tank -- Discontinue use of unit if fuel
tank shows signs of damage or leaks.
S Combination Shield -- Discontinue use of
unit if shield is damaged.
INSPECT AND CLEAN UNIT AND
LABELS
S After each use, inspect complete unit for
loose or damaged parts. Clean the unit and
label s using a dam p cloth with a m ild deter-
gent.
S Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine perform-
ance and increases fuel consumption and
harmful emissions. Always clean after every
5 hours of operation.
1. Clean the cover andthearea around it to
keep dirt from falling into the carburetor
chamber when the cover is removed.
2. Remove parts as illustrated.
NOTE: Do not clean filter in petrol or other
flammablesolventtoav oidcreatingaf irehaz-
ard or producing harmful evaporative emis-
sions.
3. Wash the filter in soap and water.
4. Allow filter to dry.
5. Replace parts.
Air Filter
Air Filter Cover
Knob
REPLACE SPARK PLUG
Replace the spark plug each year to ensure
the engine starts easier and runs better. Set
spark plug gap at 0,6 mm. Ignition timing is
fixed and nonadjustable.
1. T wist, then pull off spark plug boot.
2. Removespark plugfromcylinderanddis-
card.
3. Replace with Champion RCJ-6Y spark
plug and tighten securely with a 19 mm
socket wrench.
4. Reinstall the spark plug boot.