Filter
Top Products
1
© Copyright 2006 Printed
Before You Start
Your Land Pride Steering Lever Extension Kit is
exclusively designed for your Land Pride Accu-Z Riding
Mower. Please read these installation instructions and
your Accu-Z Operator’s Manual thoroughly before
beginning. Especially read information relating to safety
concerns. Also included in the Operator’s Manual is
important information on operation, adjustment,
troubleshooting, and maintenance for this attachment
(some manual sections do not apply to all accessories).
A separate Parts Manual for replacement parts can be
purchased from your dealer or available free of charge at
www.landpride.com. Have model and serial numbers
handy when placing an order.
Manual Part Numbers:
• Operator’s Manual . . . . . . . . . . . . . . . . . 356-005M
• Parts Manual . . . . . . . . . . . . . . . . . . . . . 356-005P
General Information
These assembly instructions apply to the following
Accessory listed below:
356-039A STEERING LEVER EXTENSION KIT
Tools required:
•
Safety Glasses
• Work Gloves
• Two 9/16" box end and/or open end wrenches
Assembly Instructions
Use the detailed listing on the back as a checklist to
inventory parts received for your Steering Lever
Extension Kit. Please contact your local Land Pride
dealer for any missing hardware.
Initial Preparations
1. Park your Riding Mower on a flat surface, move
steering levers to park, turn off engine and remove
ignition key.
When you see this symbol, the subsequent
instructions and warnings are serious - follow
without exception. Your life and the lives of
others depend on it!
!
IMPORTANT: Before you begin, read these
instructions and check to be sure all parts and tools
are accounted for. Please retain these installation
instructions for future reference and parts ordering
information.
Refer to Figure 1:
2. Disassemble steering levers (#2) from the steering
arm mounts (#1). Keep steering levers and mounting
hardware for reattachment.
Steering Lever Disassembly
Figure 1
Refer to Figure 2:
3. Attach the existing right hand steering lever (#2) and
new extension bracket (#7) to the steering arm
mount (#1) with two existing 3/8"-16 x 1 GR5 hex
head cap screws (#4) and 3/8" flat washers (#3) and
one new 3/8"-16 x 1" GR 5 hex head cap screw (#5),
two 3/8" flat washers (#6) and 3/8" hex nut (#8) as
shown.
4. Torque nuts to 35 ft. lbs.
5. Repeat steps 3 & 4 to attach the left hand steering
lever.
Steering Lever Extension Assembly
Figure 2
Accu-Z Riding Mower Z52, Z60 & Z72 Series
Steering Lever Extension Kit
2/13/06
Manual No. 356-040M