Filter
Top Products
69
Rotary Cutters, Folding Deck
330-057F continued on next page 11/30/06
Features and Benefits
Designs, specifications, features and information are subject to change without notice.
RC5510, RCM5510, RC6510 & RCM6510 Features and Benefits
Features Benefits
Surpassed rugged industry
standards
All Land Pride Cutters have been designed and tested and meet rigorous voluntary
testing procedures specified by ANSI.
Factory assembled Saves customer set-up time and money.
5 Year gearbox warranty Shows confidence in gearbox integrity.
Gearbox Seal Protection Gearbox bottom seal protection for longer bearing life.
2 3/8” Output gearbox shaft Large output shaft handles shock loads better.
250 HP Splitter gearbox High gearbox rating for rough work and high horsepower tractors.
210 HP center & wing gearboxes
55 Series
65 Series
High gearbox rating for 3 1/2" cutting capacity and high horsepower tractors.
Higher gearbox rating for 4" cutting capacity and high horsepower tractors.
540 or 1000 RPM PTO speed Fits wide variety of tractors.
Input driveline: Cat. 5 CV Holds up to shock loads and harsh mowing conditions.
Star profile drive shafts Star profile spreads load out to many points on the shaft. More apt to resist bending and
twisting under shock loads and harsh mowing conditions.
Easy Greasable drivelines Drivelines have access holes for greasing the U-joints in the driveline and to grease the
inner profiles.
4 Plate slip-clutch Protects drivelines and gearboxes by slipping clutches rather than twisting the driveline
when impacts are encountered.
High blade tip speed Allows clean cutting of material.
6” Blade overlap Eliminates skipping during turns.
High cutting capacity 55 Series
65 Series
Can cut brushy areas with saplings up to 3 1/2".
Can cut brushy areas with saplings up to 4".
12" Deck height Handles heavy cutting, which reduces balling-up of cut material under the deck.
2 to 14" Cutting height Covers a wide range of cutting conditions.
3/16” Stump jumper backed with a
1" thick mounting bar
Heavy round stump jumper with bottom gearbox seal protector. Can hold up to tough
conditions.
10 gauge smooth deck top Reduces accumulation of debris and is easier and faster to clean.
7 Gauge smooth deck bottom Heavy deck design holds up to harsh conditions. No bottom obstructions.
Deck rings (option) Keeps blades from damaging the deck.
Replaceable 1/4” wing sidewall Reduces debris piercing possibilities. Can be replaced if damaged.
Reversible / Replaceable
skid shoes
Can be reversed for extended life and can be replaced when damaged or worn out.
Self-leveling hitch Reduces drawbar wear by keeping hitch level while going through ditches.
Hinged wing section Allow you to shape the cutter to the job. Ideal for rough ground where hillsides, ditches
and hollows can cause uneven cutting.
1” Solid hinge rods Larger diameter hinge rod gives greater strength to the cutter from front to rear, and in
the hinge area itself.
Wing transport lock Holds transport wing in the folded-up position in case of hydraulic pressure loss.
Enclosed front to rear dual leveling
rods
Dual leveling rods enable the cutter to pull equally on the rear axle during travel over
rough terrain. Many competitors only use one leveling rod.
5-Bolt hubs 5-Bolt hubs makes the wheel assembly more durable and longer lasting.
Drain holes in wheel rims Allows water to drain from wheels mounted on the folded-up wing.
Helps prevent paint deterioration and rusting to the wheel rims.
330-057F continued on next page