Filter
Top Products
1
© Copyright 2005 Printed
Manual No. 308-305M
Before You Start
These optional assembly instructions contain only
information on assembling the attachment to the main
unit. Please read these installation instructions and the
vehicle Operator’s Manual thoroughly before beginning.
Especially read information relating to safety concerns.
Also included in the Operator’s Manual is important
information on operation, adjustment, troubleshooting,
and maintenance for this attachment (some manual
sections do not apply to all accessories).
A separate Parts Manual for replacement parts can be
purchased from your dealer or available free of charge at
www.landpride.com. Have model and serial numbers
handy when placing an order.
Manual Part Numbers:
• Operator’s Manual . . . . . . . . . . . . . . . . . 308-303M
• Parts Manual . . . . . . . . . . . . . . . . . . . . . 308-303P
General Information
These option assembly instructions apply to the Front
Roller Packages listed below:
308-258A OS1548 Front Roller Assembly
308-259A OS1572 Front Roller Assembly
Starting on page 3 is a detailed listing of parts included
in these kits. Use this list as a checklist to inventory parts
received.
Assembly Instructions
Installation Instructions
Refer to Figure 1 for front roller mounting hole locations.
Refer to Figure 2:
Attach the floating top link (#1) to the overseeder hitch
using the spacer tube (#2), a 3/4" x 4" long bolt (#3),
3/4" lock washer (#4) and a 3/4" hex nut (#5).
If the front roller arm (#6) and the front roller (#7) are not
assembled, bolt them together with a 1/2" x 1 1/2" long
bolt (#8), 1/2" lock washer (#9) and a 1/2" hex nut (#10).
When you see this symbol, the subsequent
instructions and warnings are serious - follow
without exception. Your life and the lives of
others depend on it!
!
IMPORTANT: Before you begin, read these
instructions and check to be sure all parts and tools
are accounted for. Please retain these installation
instructions for future reference and parts ordering
information.
Attach that assembly to your overseeder using 5/8" x 2"
long bolts (#11), 5/8" lock washers (#12) and 5/8" hex
nut (#13).
Hole Locations Typical on Both Ends of Seeder
Figure 1
Use the 1/2" x 2 1/2" x 3 1/2" long u-bolts (#15), 1/2" lock
washers (#16) and 1/2" hex nuts (#17) to attach the
turnbuckle mounts (#14). The turnbuckle (#18) should
then be attached with 5/8" x 2 1/2" long bolts (#19), 5/8"
lock washers (#20) and 5/8" hex nuts (#21).
Front Roller Assembly
Figure 2
14801
NOTE: Some of the above parts may already be
assembled.
14802
Use with 15 Series 48" & 72" Overseeder
Front Roller Option
Assembly Instructions
Manual No. 308-305M
11/08/05