Filter
Top Products
RB-525-B042
CAUTION
Always take great care when operating KW-2000. Malfunction or damage to the instrument could
occur.
Cut the power immediately if malfunction occurs during operation. Damage to the equipment or
personal injury will result. Consult your dealer, if repair work needs to be carried out.
At no time attempt to remodel or disassemble KW-2000. Damage to the instrument or personal injury
will result.
As KW-2000 is a precision optical instrument, operations must be carried out at all times by
experienced, authorized personnel. Damage to the equipment or personal injury will result.
Avoid installation near TV or radio. The reception can be disturbed by electrical noise. Follow the
manual for the proper installation.
Never remove the plug from the outlet if your hands are wet. Electric shock or personal injury could
result.
Make sure the power cord is not damaged. Fire or electric shock may occur.
Do not touch the optical parts. Measurement accuracy will be adversely affected.
The power cord must be firmly connected to an electrical ground (safety ground) at the power outlet.
Personal injury may result form electric shock, etc.
If the instrument fails to work properly, you should not try to repair the fault. Consult your dealer
immediately.
The instruction in this manual ensures correct operations.
Observe the following environmental conditions for used and storage. Avoid dew condensation at all
time.
Temperature Relative humidity
Use +10°C to +40°C 30% to 85%
Storage –10°C to +60°C below 70%
Avoid the following conditions for storage and use of the instrument.
Where noxious gases or air pollutants are present.
Where dust and grit may occur.
Where oil fumes or greasy substances are emitted.
Where there are atmospheric concentrations of salt.
Near gas generation areas and places where dust accumulates.
Keep in a secure, stable situation. Do not expose to strong vibrations (areas of seismic activity) and
sudden shocks (this includes transportation) etc.
Where there is an inclination of more than 10 degrees.
Where voltage from the power sources rises or falls sharply during loading.
Where fluctuations in the voltage of the power source occurs.
Direct contact with sunlight.
If the instructions above are not followed, damage to the equipment or personal injury will ensue.