Karcher K 2.97 M Pressure Washer User Manual


 
4
ASSEMBLY INSTRUCTIONS
Water Supply (Cold Water Only)
Water hose must be at least 3/4 inch in
diameter.
Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
The water supply temperature must not
exceed 104°F/40°C.
Step 1
Insert wheels into side holes
at the bottom of the pressure
washer and snap into place.
IMPORTANT PRECAUTIONS – continued
PRECAUTIONS
Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinner, gasoline, oil, etc.
Always prevent debris from being drawn
into the unit by using a clean water
source.
Save these instructions!
Step 2
Place the wheel carriage
onto the mounting brackets
on the sides of the washer
and align the four holes.
Snap into place.
Step 3
Slide the handle into the top
slot of the wheel carriage
and snap into place.
Step 4
Slide the trigger gun holder
into track of the pressure
washer.
Step 6
Pull out the locking slide from the right side
of the trigger gun handle, and insert the
small end of the high pressure hose into
place. Push the locking slide back into the
trigger gun to lock the hose in position.
Step 5
Attach piece at the bottom of
the pressure washer.