Filter
Top Products
INSTALLING
Installing - Page 9
IMPORTANT: Tiller MUST BE level front to rear.
• Engage the cardan shaft and check that it is perfectly
locked on the tractor PTO (G). Check that the guard
(H) is free to turn and fix it with the relative latch.
4. Raise tiller.
5. Remove spring locking pin (K) from parking stand.
6. Slide parking stand (I) and way up on tiller bracket
(J).
7. Fasten with spring locking pin (K).
8. Level tiller (See Leveling Tiller in the Operating Tiller
section).
9. Adjust sway chains on tractor lower draft arms to
minimize side way.
H
K
J
I
G
Only skid version
3. Install PTO shaft to tractor.
A
B
PTO shaft
The PTO shaft, supplied with the machine, is of stand-
ard length.
Therefore it might be necessary to adapt the PTO shaft.
In that case, before doing anything, consult the Manu-
facturer for the eventual adaptation.
When the PTO shaft is fully extended, the two tubes must
overlap by at least 6 inch (A). When fully inserted, the
minimum play must be 1,6 inch (B).
CAUTION: If the implement is used on
another tractor, always check that the
guards completely cover the rotating parts
of the PTO shaft.