Filter
Top Products
9
5. Make sure that a qualified electrician has wired the
spa to a 240 volt power source.
Remove the two warning decals (see page 5) from
the spa shell. Using a damp cloth, wipe the spa shell
clean. Before filling the spa, make sure that it is
in the desired position and that there is room to
easily service it. Once the spa is filled, it will
have to be drained before it can be moved.
Using a garden hose or other clean water source, fill
the spa. Do not use soft water. The spa may be
filled with cold water; however, if warm or hot water
is used, the spa will be ready for use sooner. Fill the
spa until the water is at the middle of the skimmer
(not shown). Do not overfill the spa.
Refer to the inset drawing. Set the Filter (5), Filter
Plug (16), Diverter (21), and Basket (22) into the fil-
ter housing. Next, screw the Filter Cover (3) into the
filter housing until it is fully seated.
3. Insert the pillow (47) into the lounge seat recepta-
cle. The pillow can be rotated 180º to change
between the high or low positions.
4. The hydrotherapy spa operates on a 240 volt power source and must be wired directly to a 240 volt Ground
Fault Circuit Interrupter (GFCI) installed in your home. This procedure must be performed by a qualified,
licensed electrician. A wiring diagram is found on the inside of the electronics package for reference.
Under no circumstances should the spa be wired by someone other than a qualified electrician. Before
you have the spa wired, make sure it is in the desired position, and that it can be easily serviced, if needed.
6. Pull down one of the straps on the Spa Cover (11)
and hold the Buckle (26) against one of the panels
on the spa. (Note: To position the Buckle correctly,
have a second person hold the strap on the opposite
side of the Spa Cover snug.) The Spa Cover must
be snug. Do not place the Buckle over the
grooves between the premium cedar panels.
Refer to the inset drawing. Remove the latch from
the Buckle (26). Attach the Buckle to the panel with
two #4 x 3/4” Screws (27).
Attach the other three Buckles (26) to the panels in
the same way.
Remove the Spa Cover (11) from the spa.
5
Fill to here
Garden
Hose
6
11
26
Strap
Strap
Latch
26
27
3
22
21
16
5
47
3