Husqvarna TS200FR Tiller User Manual


 
10
SERVICE AND ADJUSTMENTS
CAUTION: Disconnect spark plug wires from spark plug and place wire where it cannot come into
contact with plug.
TILLER
TO ADJUST GAUGE WHEELS
See “TO ADJUST TILLING DEPTH” in Operation section
of this manual.
TO ADJUST BELT (See Fig. 10)
The clutch is a belt-tightener type. Belt should be just tight
enough to prevent slipping. Over-tightening will reduce
belt life.
• To tighten belt, remove retainer spring securing belt
tight en er link to clutch lever and arm.
Standing in front of tiller, turn link in a coun ter clock wise
direction one turn at a time, until belt no longer
slips.
• After initial ad just ment, a force of approximately 10
Ibs. at the end of the lever should engage the clutch.
This would be heavy thumb pressure.
TO REPLACE BELT (See Fig. 10)
• Remove the three bolts holding belt guard to tiller.
Re move guard.
• Remove old belt.
• Install new belt so that lower side of belt is above idler
as shown.
• Adjust belt (see “TO ADJUST BELT” above).
• Replace belt guard. Make sure all moving parts will
clear belt guard.
NOTE: If it should become necessary to remove the engine
sheave, be sure that it is reinstalled so that the set screw
end is toward the outside.
FIG. 10