Filter
Top Products
SERVICE AND ADJUSTMENTS
24
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located in the engine compartment, directly
in front of the dash.
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the backside of the
grill.
• Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting.
• Check wiring. See the electrical wiring diagram in the
Repair Parts section of this manual.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 32)
• Lift hood. Disconnect headlight wiring connection.
• Remove wingnut at rear of each side panel.
• Remove retainer springs from hood pivot brackets.
• Pivot hood and side panel forward and lift off tractor.
• To replace, reverse above procedure.
FIG. 32
WINGNUT
HEADLIGHT WIRING CONNECTION
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 33)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
• With engine not running, move throttle control lever
from slow ( ) to choke ( ) position. Slowly move
lever from choke ( ) to fast ( ) position.
• Check to see if hole in throttle lever and hole in speed
control bracket are aligned.
• If holes are not aligned, loosen cable clamp screw and
align the holes by inserting a pencil or a 1/4" drill bit
through both holes.
• Pull throttle cable up to remove slack and tighten cable
clamp screw. Remove alignment pencil or drill bit.
CABLE
CLAMP
SCREW
SPEED CONTROL
BRACKET
FIG. 33
THROTTLE
LEVER