Filter
Top Products
ASSEMBLING THE MOWER
1.12
Remove the mower from the packaging and check that the following
items have been supplied correctly. If any items are missing contact,
your local Hayter dealer.
1. Engine Handbook.
Unscrew the handlebar securing knobs sufficiently to allow the handle-
bar to pivot. Move the engine stop lever away from the engine to avoid
damage and unfold the handlebar to the operating position. Make sure
the knobs are assembled to the outside of the handlebar and tighten to
secure in position.
Take care to ensure that the control cables do not become snagged at
the pivot point.
Operate the engine stop lever towards the handlebar and very slowly
pull the engine start grip (1) away from the engine until there is suffi-
cient slack in the rope to enable it to be threaded into the rope guide
(2). Release the start-grip until it rests against the rope guide as
shown. Finally tighten the nut (3) to secure the rope guide.
CS152
1
2
3
Handlebar
Delivery Checklist
Engine Start Grip
005155 (0) 28/2/05 10:34 am Page 1.12