Filter
Top Products
SKU 38413 For technical questions, please call 1-800-444-3353. Page 4
Parts List
Part Description Q’ty Part Description Q’ty
1 Base 1 10 Clamp 1
2 Right Stand 1 11 Nut M12 1
3 Blade Stand 1 12 Bolt M12 2
4 Geared Handle 1 13 Bolt M5x8 3
5 Bolt M8x16 1 14 Upper Blade 1
6 Handle 1 15 Adjusting Bolts M5x35 1
7 Handle Bushing 1 16 Adjusting Bolt M5x20 1
8 Lower Blade 1 17 Spring Washer 1
9 Bolt M8x30
1
18 Screw Driver 1
REV 03d; 03j; 05i
Maintenance
1. Periodically use a good graphite oil to lubricate blade edges and gears on the Geared
Handle (4).
2. To Replace the Blades (8, 14):
a. Open jaws completely. Be sure to use caution when replacing the blade; if the handle is
bumped the blades may move, causing personal injury.
b. Remove all three Bolts (13), replace Upper Blade (14), and secure Blade with Bolts (13).
c. Loosen Bolt (9), replace Lower Blade (8), and loosen Adjusting Bolts (15,16).
d. Adjust the Lower Blade (8) to the proper clearance for the workpiece to be cut, by using
the Adjusting Bolts (15,16).
e. After the Lower Blade (8) is properly adjusted, tighten Bolt (9) to secure it in place.