Filter
Top Products
UNFOLDING AND ADJUSTING HANDLE ASSEMBLY (See Figure 2-3)
To raise handle assembly:
• Open the lower handle locks.
• Pull up and back on the lower handle until it is aligned with the slot between the handle locks
and the mower housing.
NOTE: If the lower handle is difcult to move, turn the lower handle locks counterclockwise to free the handle.
• To secure the lower handle in place, close the lower handle locks.
NOTE: If the lower handle is loose or does not seat completely in the slot, turn the lower handle locks
clockwise to secure the handle.
• Open the upper handle locks.
• Pull up and back on the upper handle to raise it into operating position. Make sure that the
lower handle is seated in the grooves at the bottom of the upper handle.
• To secure the upper handle in place, close the upper handle locks.
NOTE: If the upper handle is loose or separated from the lower handle, tighten the knobs on the upper handle
locks by turning them clockwise.
ASSEMBLY INSTRUCTIONS
12
Fig. 2
Open
Close
Upper handle lock
Lower handle lock
Open
Close