Filter
Top Products
18
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
Before you call for service…
NOISE Possible Causes What To Do
Washer is noisy
Washer is uneven • To level the front of the washer, adjust the front leveling
legs by rotating the individual leg in the proper direction
for up or down. To level back of washer, lift back of
machine 4″ (11 cm) and set down.
Washer load is • Press START to pause the washer, open the lid and
unbalanced redistribute the load evenly. Close the lid and press
START again.
Shipping rod is still assembled • To remove shipping rod from washer, pull yellow tag and
in unit attached rod from the bottom right hand side of washer.
Washer is sitting too close • Pull washer away from the wall; about 4″ (11 cm)
to wall (causes knocking is needed.
during cycle)
PerfecTemp Plus
feature • This is normal.
PerfecTemp Plus
turns water valves off
is being used and on to adjust water temperature.
OTHER Possible Causes What To Do
Labels on the exterior
Occasionally the adhesive • Use a hair dryer set at the lowest heat setting, directing
of the washer will not
used on the labels does the air at the label for a short amount of time. This will
peel off cleanly
not release cleanly release the adhesive easily, without damaging the surface
of the washer.