Filter
Top Products
Dimensions and Installation Information
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
®
service,
800.626.2000.
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Listed by
Underwriters
Laboratories
JSS28WK/CK/BK
GE
®
30" Slide-In Electric Range
Dimension and installation information are shown in inches.
Optional Kits
(Available at additional cost)
JXS32 - Backguard
JXS56 - Lower Trim Kit
JXS86 - Vertical Side Trim Kit
JXS77 - Body Sides
Note: To reduce possiblity of scorching of the
side wall adjacent to the heating elements, it is
recommended a minimum of 6” spacing from
adjacent side walls be allowed for possible
extended, high-heat, no-load operation of
heating elements.
Receptacle Location: For all 30” Slide-In Ranges
locally approved flexible service cord or conduit must
be used because terminals are not accessible after
range installation. See shaded area in drawing for
location of electrical outlet box. Recommended outlet
locations allow range to be installed directly against
rear wall.
Note: Cabinets installed adjacent to slide-in ranges
must have an adhesion spec of at least 194.°
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
KW Rating
240V
10.8
208V
8.1
Specification Revised 9/06
320640
If you are NOT using the
optional Filler or Backguard:
23-3/16
30
If you are using the optional
Filler or Backguard:
25
30
Acceptable
Electrical
Outlet Area
30" Min
.
30" Min
.
2-7/8"
To Front
Surface Of
Countertop
20-5/8" Door
Clearance
From Front
Surface of
Countertop
31-1/4
30
35-7/8"–38"
from floor to
countertop
36-1/4
Recommended
6" Min.
From Walls
23-3/16
18" Min.
A/B*
13" Max.
2-1/2
30
25
7-1/2
2-1/2
Accessory
Backguard
24
25-3/4**
*JXS37 is 5-1/4" and JXS32 is 4"
(excluding handle)
**Total depth from wall to
front of closed oven door
including handle is 27-13/16.
Acceptable
Electrical
Outlet Area
30" Min
.
30" Min
.
2-7/8"
To Front
Surface Of
Countertop
20-5/8" Door
Clearance
From Front
Surface of
Countertop
31-1/4
30
35-7/8"–38"
from floor to
countertop
36-1/4
Recommended
6" Min.
From Walls
23-3/16
18" Min.
A/B*
13" Max.
2-1/2
30
25
7-1/2
2-1/2
Accessory
Backguard
24
25-3/4**
*JXS37 is 5-1/4" and JXS32 is 4"
(excluding handle)
**Total depth from wall to
front of closed oven door
including handle is 27-13/16.