Filter
Top Products
Fluke 196C/199C
Users Manual
72
Using the Tilt Stand
The test tool is equipped with a tilt stand, allowing viewing
from an angle while placed on a table. From this position
you can access the OPTICAL PORT at the side of the test
tool. The typical position is shown in Figure 48.
Figure 48. Using the Tilt Stand
Resetting the Test Tool
If you want to reset the test tool to the factory settings, do
the following:
1 Turn the test tool off.
2 Press and hold.
3 Press and release.
The test tool turns on, and you should hear a double
beep, indicating the reset was successful.
4 Release.
Suppressing Key Labels and Menu’s
You can hide a menu or key label at any time:
Hide any key label or menu.
To display menus or key labels, press one of the yellow
menu keys, e.g. the
SCOPE key.