Euro-Pro V1730 Lawn Sweeper User Manual


  Open as PDF
of 2
 
Style # XSY1730
for Model V1730 Sweeper
Style # XSY1730
for Model V1730 Sweeper
Service Pack Contains:
1 Replacement Brush Roll
1 Squeegee
1 Gear Box With Side Sweeper
1 Battery Pack 8.4V dc
Changing the Rotating Brush, Gear Box & Squeegee
WARNING: Use caution when changing the rotating brush, gear box and
squeegee so that the unit does not turn ON when pressing
down on the sweeper power head.
1. Remove the extension tube from the sweeper power
head.
2. Turn sweeper power head upside down being careful
Not to accidentally turn the unit ON.
3. Remove the transparent brush cover. (Fig. 1) (Refer to
your owner's manual for detailed instructions.)
4. Push in on the locking tab of the gear box and lift gear
box to remove. (Fig. 2 & Fig. 3)
5. Lift the brush bar end cap up from the slot. (Fig. 4)
6. Lift the brush bar out from the bushing and slip off the
belt to remove the brush bar. (Fig. 5)
7. Insert the new brush bar by first inserting the brush bar
into the bushing on the end opposite the driver belt.
(Fig. 5)
8. Slip the belt over the brush bar cap.
9. Insert the brush bar into the slot. (Fig. 4)
10. Insert the gear box tabs into the tab slots and push
down until it clicks into place.
11. To remove the squeegee, follow instructions above for
removing the gear box and pull the squeegee out from
the clips. (Fig. 6) To replace the squeegee, press the
new one back into the clips.
Fig. 4 Fig. 5
Fig. 1
Fig. 3
Lift
Gear box
tabs
Locking
tab
Gear box
Fig. 2
Fig. 6
Service Pack Contains:
1 Replacement Brush Roll
1 Squeegee
1 Gear Box With Side Sweeper
1 Battery Pack 8.4V dc
Changing the Rotating Brush, Gear Box & Squeegee
WARNING: Use caution when changing the rotating brush, gear box and
squeegee so that the unit does not turn ON when pressing
down on the sweeper power head.
1. Remove the extension tube from the sweeper power
head.
2. Turn sweeper power head upside down being careful
Not to accidentally turn the unit ON.
3. Remove the transparent brush cover. (Fig. 1) (Refer to
your owner's manual for detailed instructions.)
4. Push in on the locking tab of the gear box and lift gear
box to remove. (Fig. 2 & Fig. 3)
5. Lift the brush bar end cap up from the slot. (Fig. 4)
6. Lift the brush bar out from the bushing and slip off the
belt to remove the brush bar. (Fig. 5)
7. Insert the new brush bar by first inserting the brush bar
into the bushing on the end opposite the driver belt.
(Fig. 5)
8. Slip the belt over the brush bar cap.
9. Insert the brush bar into the slot. (Fig. 4)
10. Insert the gear box tabs into the tab slots and push
down until it clicks into place.
11. To remove the squeegee, follow instructions above for
removing the gear box and pull the squeegee out from
the clips. (Fig. 6) To replace the squeegee, press the
new one back into the clips.
Fig. 4 Fig. 5
Fig. 1
Fig. 3
Lift
Gear box
tabs
Locking
tab
Gear box
Fig. 2
Fig. 6