Filter
Top Products
16
G
E
D
F
U-HANDLE INSTALLATION
Tools Required: 8mm x 10mm Open End Wrench, Slotted Screwdriver,
(3mm Hex Wrench SRM-2100 only.)
Parts Required: U-Handle Kit. (SRM-2100) P/N 35130454130
NOTE
On model SRM-2110 use Steps 1, 10, 11, and 13 - 17 only.
1. Close choke and remove air filter cover.
2. Disconnect ignition stop leads (C).
3. Remove inner throttle linkage from carburetor swivel (B).
4. Loosen nut (A) and remove throttle linkage from bracket.
5. Loosen two (2) bolts (D) and pull drive shaft assembly from clutch
case.
6. Loosen two (2) rear handle screws (E) and pull rear handle (F) from
the drive shaft assembly.
7. Loosen four (4) screws and remove front handle (G).
8. Position Lower U-Handle Bracket (H) 400mm (15-3/4 in.) from
engine end of drive shaft. Secure with three (3) 5mm x 30mm
bolts.
9. Install harness hook (included with Blade Conversion Kit) for
blade use. Position 220 mm (8-5/8 in.) from engine end of drive
shaft assembly. DO NOT tighten at this time.
10. Install upper U-Handle and bracket on lower bracket and secure
with one (1) 8mm x 55mm bolt (J) and large circular washer.
J
400 mm (15-3/4 in.)
220 mm
(8-21/32 in.)
ENGINE
END
H