Echo PAS-2100 TYPE 1E Brush Cutter User Manual


 
8
assembly
WARNING
Do not perform maintenance or assembly procedures with engine running.
Parts Required: Power Head Shaft, Attachment Lower Shaft
Assembly, Metal Shield, Bracket, Barrier Bar
D
A
A
B
D
B
power head shaft/attachment lower shaft assembly
1. Set Power Head/Shaft Assembly on a level surface.
2. Pull locator pin (A) and rotate counter clockwise 1/4 turn to lock
out position.
3. Remove vinyl cap from attachment drive shaft.
4. Remove cardboard spacer, if necessary.
5. Carefully t attachment lower drive shaft assembly into coupler
(B) to decal assembly line (C), making sure that the inner lower
drive shaft engages into the upper drive shaft mount.
C
D
NOTE
Earlier model Power Heads may have shorter couplings. Short
couplings t ush to decal point (E). New couplings are 4-3/4 in.
long, and t ush to line (C).
NOTE
Lower bearing housing and head assembly must be in line with the
engine.
6. Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft
hole. Insure locator pin is fully engaged by gently twisting
lower drive shaft. Locator pin (A) should snap ush in coupler.
Full engagement will prevent further shaft rotation.
7. Secure lower shaft assembly to coupler by tightening clamping
knob (D).
A
E