DVS 99000153 Blower User Manual


  Open as PDF
of 4
 
Blower, DVS Gas (Berkshire, Tree of Life, Prairie, Cedar, 2001 Allegiance) Part # 99000153
Page 1 of 4 4070219
CHECK CONDITION OF SHIPMENT
Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on the carrier's freight
receipt. Any damage claims as a result of shipping must be handled through the shipper. Travis Industries will provide assistance
in resolving shipping claims or replacing items not included in the package. Please report any missing items immediately.
COMPATIBILITY
• Lopi Berkshire • Tree of Life • Avalon Prairie • Avalon Cedar • Lopi Allegiance (2001 model)
ITEMS NEEDED FOR ASSEMBLY
• 11/32” Socket Wrench • 1/4” Nutdriver • 1/2” Open End Wrench
PACKING LIST
• Blower Assembly • Wiring Harness • Thermodisk • Two Rubber Grommets (with spacers)
• Two Nuts and Washers • Stud Plate • Rheostat (with attachment nut & lock washer) • Rheostat Knob
INSTALLATION INSTRUCTIONS
WARNING: Turn the gas control valve to off and make sure the appliance has fully cooled prior to
conducting service.
1 Attach the two black wires on the included wiring harness to the thermodisk (orientation does not matter). Then slide
the thermodisk into the holder underneath the burner pan at the right rear of the stove.
All Models
Except the
Tree of Life and
2007 Berkshire
Snap Disk Bracket
(attached to stove)
Snap Disk
Snap Disk Wires on Wiring Harness
(Black - orientation does not matter)
Back of
Stove
Tree of Life
and
2007 Berkshire
Snap Disk Wires
(Black - orientation
does not matter)
Back of Stove
Remove the snap disk cover plate below
the burner on the
left side (when facing
the stove from the front).
Attach the snap disk
using the screws
removed in step "a".
a
b
c
Attach the wires
labeled snap disk to
the snap disk.
next