installation instructions
For BloWEr Kit MoDEl DVFFBK
WARNING: Disconnect all electrical power to the
1. To remove lower louver, pull both top spring latches toward
the center of the appliance at the same time until they are
disengaged from the locating holes. Repeat for bottom spring
latches and pull louver outward.
2. Placeblowerassemblysoitrestsushagainsttheinside
wallontheueexitsideoftherebox(seeFigure1).There
are four magnets on the bottom of the blower assembly that
willkeeptheblowerinplaceonreboxbottom.Note: If the
blowerkitisnotinstalledushagainsttheinsidesidewallof
thereplace,thecirculatingairfromtheblowersystemwill
notowproperly.
1. To operate blower, turn the blower speed control knob
clockwisetotheONposition(seeFigure3).Thiswillbe
the highest blower speed. Continue turning knob clockwise
toreduceblowerspeed.Turnknobonlywithinthespecied
range(1/4revolution,seeFigure3).
2. To turn blower off, turn blower speed control knob counter-
clockwiseuntilitclicksintotheOFFposition.Youmustturn
until knob clicks for the unit to be completely off.
Figure 1 - Blower Assembly Placement
Blower
Assembly
Figure 2 - Blower Speed Control Location
Glass
Speed
Control
Spring Latch
BLOWER
SPEED
CONTROL
BLOWER
ASSEMBLY
BLK (16 ga.)
BLK (16 ga.)
Wire Connectors 3 Places
Figure 4 - Wiring Diagram for Blower Assembly
Magnet
High Speed ON/OFF
Low
Speed
Magnets
1/4 Revolution
107514-01
REV. B
02/06
2701 Industrial Drive
PO Box 90004
Bowling Green, KY 42102-9004
NOT A UPC
Figure 3 - Blower Speed Control
Blower Center to
Firebox Bottom
Center Along Inside
Wall by Flue Exit
Peninsula or See-Thru
Fireplace Installed
Flue
Exit
107514 01
Inside
Wall
1. Place speed control switch assembly on the bottom of the inside of
therebox(seeFigure2).Theassemblyisequippedwithmagnets
ontheleftandrighttoproperlyanchorittotherebox.
2. Plug blower with speed control assembly into a power source.
Keep hands clear of fan when running.